10
2 | SCANNER SETUP
INSTALLING BATTERIES AND ATTACHING THE TETHER
1. Use a coin or screwdriver to unlock and remove the battery cover. Turn the lock
underneath the scanner to a horizontal position to unlock.
2. Remove the battery cover.
The Bluetooth Address is printed on a label inside the battery compartment. It helps
you distinguish your CHS from other CHS scanners. If you install SocketScan 10, you can
also check the Bluetooth Address in Scanner Settings.
3. Install the batteries in their correct positions, as indicated by the +/- symbols.
Revision Letter - follows Part Number
Bluetooth Address
To Next Page
Loading...
