CHAPTER 6: SETUP FOR SOCKET SOMO 67
OPTION 1: USING THE CHS IN HID MODE
To pair the CHS with your SoMo:
You only need to pair the CHS with your SoMo the first time you try to connect.
1. Power on the CHS. Press and hold the small power button until the LED turns blue and
the CHS beeps twice (low-high).
The LED blinks blue once per second to show that the Bluetooth radio is on but not
connected.
2. Scan this barcode to configure the CHS for HID mode for peripherals. Afterwards, the
CHS will beep 3 times.
The CHS must be in HID mode first before you scan the barcode above. By default,
the CHS is in HID mode. If the CHS was changed to SPP mode, use the Command
Barcodes to change it to HID mode.
3. In the Today screen, tap on the line that lists Wi-Fi and Bluetooth status.
Alternatively, press the button on the right side of the SoMo, which launches the
wireless manager by default.
To Next Page
Loading...
