Socket 7Ci - Page 73

CHAPTER 6: SETUP FOR SOCKET SOMO 73
To pair and connect the CHS with the SoMo:
You only need to pair the CHS with your SoMo the first time you try to connect.
The following instructions are based on Socket EZ Pair, a feature of SocketScan 10
software. For instructions on how to connect by generating and scanning a special
barcode (ActivePairing), please see Appendix G
.
1. Power on the CHS. Press and hold the small power button until the LED turns blue and
the CHS beeps twice (low-high).
The LED blinks blue once per second to show that the Bluetooth radio is on but not
connected.
2. Make sure Bluetooth is enabled. In the Today screen, check the Bluetooth status
.
If Bluetooth is off, tap on the Bluetooth status line. In the Radio Manager, tap on the
Bluetooth button. After Bluetooth is enabled, the red “x” will disappear from the
button. Tap OK.
3. Tap Start
| Programs | SocketScan 10 folder | SocketScan 10 .