100 | APPENDIX F COMMAND BARCODES
Automatic Reconnection Settings
ENABLE Automatic Reconnection from CHS (default)
Configures the CHS to automatically initiate a connection to the last paired
computer / device after the CHS is powered on.
DISABLE Automatic Reconnection from CHS
Configures the CHS to wait for a computer / device to initiate a Bluetooth
connection after the CHS Is powered on.
After scanning the Enable/Disable Automatic Reconnection from CHS command barcode
above, power off and power on the CHS to make sure it is configured properly!
Factory Defaults
Factory Reset
Configures the CHS to revert all settings to factory defaults. The CHS will power
off after scanning this barcode.
Data Suffix — For HID Mode
Data As Is
Configures the CHS to return
only the decoded data (i.e.,
no prefix or suffix).
Suffix – Carriage Return
(default)
Configures the CHS to add a
carriage return after decoded
data.
Suffix – Carriage Return &
Line Feed
Configures the CHS to add a
carriage return and line feed
after decoded data.
Suffix – Tab
Configures the CHS to add a
tab after decoded data
To Next Page
Loading...
