74
Scanner Settings
You can access Scanner Settings only when the CHS is connected to your PDA.
1. Tap on the CHS icon
in the task tray. In the pop-up menu, tap Scanner
settingsā¦
2. The CHS will disconnect from SocketScan 10, indicated by two beeps. The Scanner
Settings screen will appear with an empty field.
3. After a few seconds, the CHS will connect to Scanner Settings and beep once. Your
CHS will appear in the list. Make sure your CHS is selected, and tap Properties.
4. After the utility has read you scanner settings, the General properties screen will
appear, reporting the Bluetooth friendly name, Bluetooth Device Address, Type of
device, firmware version, and battery level.
If desired, tap in the Name field to change the Bluetooth friendly name of the CHS.
To Next Page
Loading...
