Socket 8 Series - Connect Android Device (continued)

SPP MODE
10
Connect Android device in SPP Mode
15. Select [On screen] button.
16. On the next screen, tap on the 8Ci [1D Scanner] or 8Qi [2D Scanner]
button that is appropriate for your scanner button.
17. Scan the barcode on the screen. The CHS will beep 3 times.
18. Whennotiedofapairingrequest,swipethenoticationdownthen
tap Pairing request.
19. On the next screen, tap Pair.
20. The CHS will beep once to indicate connected state and is ready to
scan barcodes. Tap Back to close Socket EZ Pair.
21. If you are connecting a scanner which is not registered, a CHS
registration icon will appear on top of the screen. Swipe the icon
down to open the registration pages. Follow the instructions
to register your CHS. Socket Mobile highly recommends that all
customers register their products, but registration is not necessary.
Now you are ready to scan barcodes!
Note: If you are unable to scan the barcode on screen, please refer to
the alternative Bluetooth Method to connect the CHS in the User Guide
at Socket Mobile’s support web page.