Socket CHS - Page 10

18
iOS MODE
Connect Apple device in iOS Mode
Please check with your scanner application vendor or visit
www.socketmobile.com/appstore to conrm your Scanner-enabled
application supports the CHS.
If you are using the CHS with an Apple iOS device and a Scanner-enabled
Application that does not provide instructions how to connect with the
CHS, please use the following steps.
1. Power on the CHS. Make sure the CHS is discoverable (unpaired).
2. To change the prole to iOS mode scan this barcode. The CHS will
beep 3 times.
Use with iPad, iPod touch, and iPhones.
19
iOS MODE
3. Turn Bluetooth on the Apple device. Go to Settings > Bluetooth.
A Bluetooth Devices search will begin.
4. Tap Socket CHS[xxxxxx] in the list of Devices found. After a few
seconds the “Not Paired” status will change to “Connected” and the
CHS Blue LED will blink every 3 seconds conrming the connection.
Note: The characters in brackets are the last 6 characters of the
Bluetooth Address. The full Bluetooth address is printed on the Product
label.
5. Open the Scanner-enabled Application. The CHS will beep once
indicating that it is connected to the appropriate application.
Now you are ready to scan barcodes.