Socket SocketScan - Page 106

106
Decoding Security, GID = 0x71
Beep/LED Indicator, GID = 0x72
ISCP Parameters, GID = 0x73
Configuration, GID = 0x74
Imager, GID = 0x7B
Function FID Default Parameter
consecutive same read data validation 40 0
timeout between identical
consecutive codes
80 300 ms
timeout between different
consecutive codes
81 0 ms
Function FID Default Parameter
beep frequency 80 2090 Hz
good read beep duration (ms) 81 50 ms
green LED duration (ms) 82 50 ms
error beep 43 enabled
setup beep 44 disabled
Function FID Default Parameter
data format 40 raw data
"setup modification by configuration
bar code" event
41 disabled
"configuration bar code rejected"
event
42 disabled
"start of read session" event 47 disabled
"end of read session" event 48 disabled
"start-up" event 49 disabled
"trigger pulled" event 4A disabled
"trigger released" event 4B disabled
Function FID Default Parameter
configuration by bar codes 40 always enabled
Function FID Default Parameter
decode mode 40 2D imager
lighting goal 42 28