87
Setting Up the EA15
You can set up your EA15 using one of these two methods:
• Send software commands from your host system using the Intermec
Scanner Control Protocol (ISCP). For help, see the ISCP Technical
Reference Manual available (limited access) from the Intermec web site at
www.intermec.com or through your Intermec representative.
To help you get started with ISCP, Intermec provides ISCP support
documents. These documents are available upon request from your
Intermec OEM Sales Representative:
• DLL file for implementation of ISCP
• API documentation that describes how to use the DLL file
• Sample application (Windows and DOS)
• Sample application source code
• Scan configuration bar codes created using EasySet®. EasySet is an
Intermec configuration application that is available at no charge from
the Intermec web site at www.intermec.com. For more information
about EasySet, see the EasySet software.
This section provides you with the bar codes necessary for a basic setup. For
advanced setup options, use EasySet.
To setup your EA15
1 Scan the reset factory defaults bar code:
reset factory defaults
\60\08/55/24
Note: The default RS-232 settings are 57600 baud rate, 8 data bits, and no
parity. Data bits and parity are fixed ISCP parameters that can only be
changed when ISCP is not active. An asterisk symbol (*) indicates the
default value.
To Next Page
Loading...
