56
Set Lengths for Discrete 2 of 5
Parameter # L1 = 0x14, L2 = 0x15
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for D 2 of 5 may be set for any length,
one or two discrete lengths, or lengths within a specific range. To set lengths via serial
commands, see Setting Code Lengths Via Serial Commands on page 10.
One Discrete Length - Select this option to decode only those codes containing a selected
length. For example, select D 2 of 5 One Discrete Length, then scan 1, 4, to decode only
D 2 of 5 symbols containing 14 characters. Numeric bar codes begin on page 82. To
change
th
e selection or cancel an incorrect entry, scan the Cancel bar code on page 84.
D 2 of 5 - One Discrete Length
Two Discrete Lengths - Select this option to decode only those codes containing two
selected lengths. For example, select D 2 of 5 Two Discrete Lengths, then scan 0, 2, 1,
4, to decode only D 2 of 5 symbols containing 2 or 14 characters. Numeric bar codes
begin on page 82. To change the selection or cancel an incorrect entry, scan the
Cancel bar code on page 84.
D 2 of 5 - Two Discrete Lengths
To Next Page
Loading...
