socomec DIRIS Digiware M-70 - EasyConfig System Configuration; USB Connection Mode Configuration

34 EN
DIRIS Digiware M-50 & M-70 - 548751B - SOCOMEC
11. CONFIGURATION VIA EASY CONFIG SYSTEM
The EasyCong System software can be downloaded from the Socomec website at the following link:
https://www.socomec.com/easy-config-software_en.html
The Conguration of the DIRIS Digiware M-50/M-70 gateway and downstream Socomec devices can be done from the
EasyCong System software, by connecting a computer to the M-50/M-70 gateway either via USB or via Ethernet.
11.1. USB connection mode
DIRIS Digiware
M-xx
DIRIS B
RS485
Digiware Bus
Digiware system
EasyConfig System
ETHETH
ETHDIGIWARE
BUS
24 V
20 W max
SUPPLYRS485
NC
ADDR.
ALARM
ON
COM
DIRIS M-xx
USB
> Open EasyCong System.
> Connect a USB cable between the DIRIS Digiware M-50/M-70 gateway and a computer.
> Log in as User or Admin. Admin default password is “Admin”.
> Click on “New Conguration”, enter a name and icon.
> Click on the newly created conguration.
> Click on “USB mode” on the right top corner to connect to the M-70/M-50 gateway and access
conguration menus.
> Click on the “Binocular” icon on the left side bar.
> Under the “Organisation” part, select the M-70/M-50 gateway.
> Click on “Dashboard” to visualise general information about the gateway.
> Click on “Auto-discovery” (1):