5. 1. ‘com-sLots’ LocaLisation
The « Com-Slots » integrates all communication interfaces and it is located on the right side.
Please, see on the manual of the concerned UPS to see the correct localisation of the «com slot 2»
5. 2. modbUs sEriaL intErfacE PLUg in
The serial interface should be plugged in the slot 2, and xed with 2 crews.
5. 3. modbUs intErfacE in ParaLLEL sYstEm configUration
There is only one MODBUS serial link interface for a parallel system configuration. One serial interface
is used for the whole installation. The access to the data of the UPS module or unit is managed by the
table addressing .
In a parallel installation with centralized bypass, it is recommended to install the serial card in slot 2
of the bypass.
1
2
5. INSTALLATION OF MODBUS RTU CARD
6
Delphys green power - Ref.:
IOMDGPJB0910-GB_11
To Next Page
Loading...
