Need help?Do you have a question about the socomec Modulys GP 2.0 Series and is the answer not in the manual?
General| Modular | Yes |
|---|---|
| Topology | Double conversion |
| Frequency | 50/60 Hz |
| Efficiency | Up to 96% |
| Communication Interface | RS232, Ethernet |
| Operating Temperature | 0°C to 40°C |
| Humidity | 0 to 95% non-condensing |
| Protection | Overload, short circuit, overtemperature |
| Standards | IEC 62040-1, IEC 62040-2 |
Describes the physical installation and cabling of the RTU interface card.
Explains how to install the MODBUS TCP interface card into the UPS.
Describes the auto baud rate procedure for serial connection parameters.
Details the technical features and LED indicators of the MODBUS TCP card.
Lists generic MODBUS addresses, lengths, types, and access modes for UPS data.
Explains the modular unit structure and MODBUS access for MODULYS GP.
Maps module addresses within the MODULYS GP UPS structure.
Covers additional status bits for board slots and programmable options.
Describes programmable status bits for custom input/output configurations.
Provides a summary of module operating status and availability.
Details programmable alarm bits for custom input/output configurations.
Summarizes general alarms for individual modules.
Lists configuration parameters for ITYS PRO UPS with their addresses and values.
Covers additional status bits for board slots and programmable options.
Describes programmable status bits for custom input/output configurations.
Details programmable alarm bits for custom input/output configurations.
Illustrates the architecture of Masterys units and parallel systems.
Explains how to map unit addresses for accessing data in Masterys systems.
Covers additional status bits for board slots and programmable options.
Describes programmable status bits for custom input/output configurations.
Provides a summary of general alarms for parallel system units and modules.
Summarizes imminent stop alarms for individual units.
Details programmable alarm bits for custom input/output configurations.
Provides a summary of general alarms for parallel system units and modules.
Summarizes imminent stop alarms for individual units.
Lists the MODBUS functions (0x03, 0x06, 0x10) employed in the protocol.
Details the byte structure and components of MODBUS frames for different functions.
Shows the Digi Device Discovery interface for network configuration.
Details how to configure IP settings for network interfaces.
Shows an example frame for a MODBUS TCP request from a master.
Shows an example frame for a MODBUS TCP reply from the UPS.
To Next Page