EasyManua.ls Logo

socomec NETYS PR 1500 Rack 1U - User Manual

socomec NETYS PR 1500 Rack 1U
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
NETYS PR
1000-1500 VA RACK 1U
安装及操作手册
CN
Installations- und bedienungsanleitung
DE
Manual de instalación y uso
ES
Manuel d’installation et d’utilisation
FR
Installation and operating manual
GB
Manuale di installazione e uso
IT
Прирачник за инсталација и употреба
MK
Installatie– en bedieningshandleiding
NL
Dokumentacja Techniczno-Ruchowa
PL
Manual de instalação e funcionamento
PT
Manual de instalare şi utilizare
RO
Руководство по установке и эксплуатации
RU
Navodila za priključitev in uporabo
SI
Kurulum ve kullanım kılavuzu
TR

Table of Contents

Questions and Answers

  • K
    Katherine AdkinsAug 14, 2025
    What to do if socomec NETYS PR 1500 Rack 1U UPS beeps every second?
    • J
      John SuttonAug 14, 2025
      If your Socomec UPS is beeping once per second because the power requirements exceed the UPS capacity (overload is greater than 110%) or the load is defective, the UPS will automatically shut down in 3 minutes. You should immediately save your work and turn off your equipment. Turn off the UPS. Remove some of the equipment from the UPS. You may need to obtain a larger capacity UPS. The alarm cannot be silenced.
  • J
    Jeffrey GarciaAug 17, 2025
    What to do if socomec UPS operates in battery mode?
    • D
      Daniel GonzalesAug 17, 2025
      If your Socomec UPS operates in Battery mode only, even though normal utility power is present, it might be that the input circuit protector is open (230V models only). Save your work and turn off your equipment. Turn off the UPS. Reduce the load, then press the input circuit protector on the UPS rear panel.
  • N
    Nancy KellyAug 21, 2025
    What to do if my socomec NETYS PR 1500 Rack 1U UPS doesn't start?
    • M
      Matthew FisherAug 21, 2025
      If the indicator is not on and your Socomec UPS does not start, it could be due to several reasons: * The power cord is not connected correctly. Check the power cord connections. * The UPS is in Standby mode. Press and hold the button until you hear the UPS beep (approximately two seconds) to supply power to the connected equipment. * The wall outlet is faulty. Replace the input fuse with another of the same type or reset the automatic switch.
  • S
    Samuel VillegasAug 25, 2025
    Why socomec UPS doesn't provide expected backup time?
    • Z
      Zachary VargasAug 25, 2025
      If your Socomec UPS does not provide the expected backup time, it could be because the batteries need charging or service. Plug the UPS into a power outlet for 24 hours to charge the battery. Press the button; if the alarm beeps, replace the battery. During extended power outages, turn off the UPS after saving your work and shutting down your computer to conserve battery power. Alternatively, the UPS could be operating in Normal mode.
  • W
    William FloresAug 27, 2025
    What to do if socomec NETYS PR 1500 Rack 1U UPS beeps every 4 seconds?
    • M
      Martin HaleAug 27, 2025
      If your Socomec UPS beeps every 4 seconds, it indicates that the UPS is running on battery power due to a utility failure. Prepare your equipment for shutdown. If this is an extended power outage, save your work and turn off your equipment to conserve battery power.
  • T
    Taylor ChandlerAug 30, 2025
    What to do if socomec UPS beeps every 2 seconds?
    • D
      Donna OrozcoAug 31, 2025
      If your Socomec UPS is beeping every 2 seconds because the UPS is running on battery power because the input voltage is too high (>149V for 120V models; >290V for 230V models) or too low (
  • B
    brownsamanthaSep 3, 2025
    What to do if socomec UPS beeps once per second?
    • M
      millermichelleSep 3, 2025
      If your Socomec UPS is beeping once per second because the UPS is on battery, and the power requirements exceed UPS capacity (overload is greater than 110%) or the load is defective, shutdown is imminent (30 seconds). Save your work and turn off your equipment. Turn off and unplug the UPS. Remove some of the equipment from the UPS. Wait at least 5 seconds until all LEDs are off and restart the UPS. You may need to obtain a larger capacity UPS. The alarm cannot be silenced.
  • G
    georgekimberlySep 6, 2025
    What to do if socomec UPS beeps continuously?
    • J
      Jonathan DavisSep 6, 2025
      If your Socomec UPS is beeping continuously due to a battery test failure, check the battery connections and be sure the battery is fully charged. If the indicator still flashes, replace the battery. Call your service representative if the problem persists.
  • W
    williamsbradSep 10, 2025
    What to do if socomec NETYS PR 1500 Rack 1U gives 3 beeps every 10 seconds?
    • K
      Kristy SmithSep 12, 2025
      If your Socomec UPS gives 3 beeps every 10 seconds, it means there was a failed attempt to start the UPS on battery. Plug the UPS into a power outlet for 24 hours to charge the battery. After charging the battery, press and hold the button for 3 seconds; then check the indicator. The alarm cannot be silenced. If the indicator still flashes, replace the battery.

Summary

Safety Standards

Important Safety Instructions

Critical safety instructions and precautions for operating and maintaining the UPS.

Installation

Mounting in 19-inch Rack

Step-by-step guide for installing the UPS into a standard 19-inch rack.

Mounting in 23-inch Cabinet

Front View

Control Panel Functions

Detailed explanation of the UPS control panel buttons and indicator lights.

Internal Battery Connection

Accessing and Connecting Battery

Procedure for removing the front panel and connecting the internal battery connector.

Additional UPS Features

Voltage Configuration

Guide to configuring output voltage and input voltage range using DIP switches.

Troubleshooting

Silencing Audible Alarms

Procedure for silencing audible alarms and resolving common UPS issues.

Alarm and Condition Resolution

Table of common alarm conditions, possible causes, and recommended actions.

socomec NETYS PR 1500 Rack 1U Specifications

General IconGeneral
CategoryUPS
ModelNETYS PR 1500 Rack 1U
Form FactorRackmount
Power Rating1500 VA
Output Power1350 W
Input Voltage230 V
Output Voltage230 V
Output WaveformSine Wave
Frequency Range50/60 Hz
Communication PortsUSB, RS232
Warranty2 years
TopologyLine Interactive
Battery TypeSealed Lead Acid
Operating Temperature0°C to 40°C
Storage Temperature-15°C to 45°C
Humidity0 to 95 %, non-condensing
Efficiency≥ 95 %

Related product manuals