Recharging
SC31T offers a USB-C port for convenient recharging of its 18650 battery. Please
connect it with the included USBA to USBC cable and use a USB power adapter (not
included) with 5V 1A. While charging the LED power indicator flashes red. Once
finished the indicator will turn green to indicate a full battery. If the the indicator
flashes Green and Red alternately, please check if insulating paper was removed and
if the tail and tube are screwed tightly.
*Never charge a non-rechargeable CR123A inside SC31T.
Operation Instructions
ON/OFF
Tap tail switch for momentary-on. Push down till a click for constant on. Single click
turns it off.
Change Brightness or Modes
While ON, press and hold to side switch to cycle through stepped modes: Eco-Low –
Medium – High (Stepped mode group); or stepless ramping from 1LM to 1900LM
(Ramping Group). 4 fast clicks to toggle between the two groups.
Double click to activate Turbo mode. While in Turbo mode, single click to return to
the previously used mode
Triple click to activate Strobe, double to cycle through Strobe-SOS-Beacon, another
click goes back to previous mode.
While OFF, hold side switch, and click tail switch, you have moonlight mode.
Toggle between Stepped mode group and Ramping Group
From ON, 4 fast clicks to cycle between both mode groups.
Safety Instructions
SC31T is a powerful flashlight. Never point it directly at a person, animal or
moving vehicles. Doing so could cause retinal damage. Please do not allow
children to play with it. Strobe mode may cause seizure in persons with
photosensitive epilepsy.
Operating SC31T for a long time in high powered modes will quickly heat up the
flashlight. This is normal.
Pay close attention to the proper installation of the battery. Always check that the
positive end of the battery is visible when you unscrew the head from the tube
before screwing the tube back on.
To Next Page
Loading...
