Battery Installation
Before first use, please unscrew the tail cap and remove the insulating sticker. If the
battery needs to be replaced, please make sure that the positive end of the new battery
faces the flashlight’s head when you put the battery in.
Battery Level Indicator
The indicator shows the power status for 5 seconds after turning SD09 on.
Green = remaining battery power is 75%-100%.
Flashing Green = remaining battery power is 50%-75%.
Red = remaining battery power is 25%-50%
Flashing Red = critical power (less than 25%), please replace or recharge
battery as soon as possible.
Operation Instructions
ON/OFF: Press and hold the switch to turn the light on/off.
CHANGE BRIGHTNESS LEVEL: When the flashlight is on, single-click the
switch and it will start from the present brightness level, cycle through Low, Medium,
and High modes. The mode is selected when the switch has been released.
DIRECT ACCESS TO STROBE MODE: When the flashlight is on/off (not in lock
mode), quickly double-click the switch to activate Strobe mode, and single-click
again to return to the previously used mode.
LOCK/UNLOCK: When the flashlight is off, 2 fast clicks on the switch to lock the
flashlight. LED blinks twice to signal that the light is in lock mode. And two clicks on
the switch to unlock it returning to previously used mode. You can only access to
momentary-low by holding the switch while being locked. LED will flash twice to
indicate the flashlight is in lock mode when you try other operations.
To Next Page
Loading...
