Operation manual of solar water controller SR530C8/SR530C8Q
---------------------------------------------------------------------------------------------------------------------------------------------------
- 6 -
►fix cover by using screw ①②。
2.3 Power connection
Power can only be switched on when the house of controller is closed, an installer must
make sure that the IP protection class of the controller is not damaged during
installation.
Depending on the type of installation, the cables may enter the device through the rear
hole of the case ④or the lower side hole of the case ⑤
Cable come from the rear ④: remove the plastic flaps from the rear side of the case
using an appropriate tool.
Cable come from the below⑤: cut the left and right plastic flaps using an appropriate
tool (e.g. knife) and break them out of the case.
Notes: the flexible wire must be fastened on the case using the clamps provided
To Next Page
Loading...