SolarEdge SE20K - Page 50

2.
Verify that SolarEdge SetApp is installed on your mobile device.
3.
Remove the cover from the Power Bank input port at the bottom of the Synergy
Manager. Connect the USB cable between the Power Bank and the input port -
Upon connection, all LEDs light steady for one minute, and then alternate blue /
green.
NOTE
Alternating red / blue LEDs indicat a poblem with the power bank.
Figure 25: Pre-commissioning the inverter
4. Start SetApp on your mobile device and follow the on-screen instructions.
5.
When instructed, hold the ON/OFF/P Switch in P position and release within two
seconds.
6. If the Synergy Manager is equipped with a DC Disconnect Switch, turn it to ON
position.
7. Continue to follow the on-screen instructions to set the inverter.
8. When instructed, disconnect the power bank and cover the power bank input port.
9. Turn-off the DC Disconnect Switch or the ON/OFF/P Switch.
10. Wait until the inverter shut off (all LEDs turn-off).
11. Turn-on the DC Disconnect Switch and ON/OFF/P Switch.
Three Phase Inverter with Synergy Technology P/N: SExxK-xxxxIxxxx SExxK-xxxxIxxxx
49 Pre-commissioning (Off-Grid)