SolaX Power X1-3.0-S-D User Manual

1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
Relay Fault Relay Fault
EEPROM Fault
Comms Lost
Bus High
TZ Fault
Other Device Fault
Inv EEprom Error
Mgr Eeprom Fault
Include SPI,SCI Faults
Bus Volt Fault
Tz Protect Fault
SW OCP Fault
Other Device Fault
PLL Lost Fault
7. Troubleshooting6. Operation
Indicator Fault Description
7. Troubleshooting
7.1 Troubleshooting
Troubleshooting List
This section contains information and procedures for solving possible problems
with the X1 series inverter, and provides some troubleshooting tips to identify
and solve most problems that could occur with X1 series inverter.
This section will help you narrow down the source of any problems you may
encounter. Please read the following troubleshooting steps.
Check the indicator light state. Record it before anything further solutions.
Attempt the solution indicated in troubles shooting list.
If the indicator lamp unlit, check the following list to make sure that the present
state of the installation allows proper operation.
- Is the inverter located in a clean, dry, adequately ventilated place?
- Have the DC input breakers been opened?
- Are the cables adequately sized and short enough?
- Are the communication cable properly connected and undamaged?
Please contact SolaX Power company customer service for further assistance.
Please be prepared to describe details of your system installation and provide
the model and serial number of the unit.
PV Volt Fault
Isolation Fault
Temp Over Fault
Fault Description
DCI Fault
- Check the panel’s open circuit voltage whether the value
is similar or already ＞Max. DC voltage.
- Please seek help from us when voltage ≤Max. DC
voltage.
- Check the connection of the inverter.
- Or seek help form us.
- Check the connection of the inverter.
- Or seek help form us.
- Check the connection of the inverter.
- Or seek help form us.
2726

SolaX Power X1-3.0-S-D Specifications

General

Brand	SolaX Power
Model	X1-3.0-S-D
Category	Inverter
Language	English