Solid State Logic SSL 4K E User Manual

Sidechaining
The 'EXT' (External) toggle in the Routing Menu feeds the Dynamics module fed
from an external sidechain, routed from your DAW. Check your DAWs
documentation on how to route a signal to a plug-ins sidechain input.
e.g. you could route a kick drum signal to the sidechain input of a plug-in instance on
your bass guitar track, and toggle 'EXT' in. This would trigger the compressor the a
bass guitar from the kick signal, causing the bass guitar to be 'ducked' when the kick
occurs.
The high- and low-pass filters and EQ modules can be moved into the Dynamics
sidechain, using the circular toggles in the Routing Menu. The 'EQ' toggle
corresponds to 'EQ to Sidechain' and the 'FILTERS' toggle corresponds to 'Filters to
Sidechain'.
Advanced Settings
Advanced Settings - Output
Analogue VCA
This option can be set to 'off' to remove the saturation element that is added at the
VCA fader output stage.
Width Mode
Full - the width control affects all frequencies equally
Low - the width control only affects frequencies below the Width Frequency
High - the width control only affects frequencies above the Width Frequency
Use this in combination with the Width Frequency control to e.g. only mono
frequencies below 120Hz, or only widen frequencies above 10 kHz.
Width Frequency

Solid State Logic SSL 4K E Specifications

General

Brand	Solid State Logic
Model	SSL 4K E
Category	Recording Equipment
Language	English