Solid State Logic THE BUS+ User Manual

Settings Mode & Factory Reset
23
THE BUS+ User Guide
Side Solo Mode
In normal operation, the Side signal when solo'd is presented on both left and right outputs, in phase. This can be changed to
be presented after passing through the M/S decoder, which gives in-phase Side signal on the Left output and out-of-phase Side
signal on the Right output.
You toggle the Side Solo mode by pressing the CH 2 IN switch.
If the CH 2 IN switch is YELLOW, the Side signal is presented on both left and right outputs, in phase
If the CH 2 IN switch is ORANGE, the Side signal is presented after passing through the M/S decoder.
Right-Hand Side Meter On/Off - Stereo Modes
By default, in normal operation if The Bus+ is in Classic Stereo or � S/C
Stereo modes then the right-hand side gain reduction meter is disabled.
However, this can be changed so that both meters light up and operate in
these stereo modes.
You toggle the right-hand side meter to be on/off in stereo modes pressing
the CH 1 IN switch.
If the CH 1 IN switch is DIM WHITE, the right-hand side meter is disabled in
stereo modes (default).
If the CH 1 IN switch is BRIGHT WHITE, the right-hand side meter is enabled
in stereo modes. The backlight of the right-hand side meter will also reflect
the current setting.
Side solo = left and right, in phase Side solo = presented through M/S decoder
Right-hand side meter disabled Right-hand side meter enabled

Solid State Logic THE BUS+ Specifications

General

Brand	Solid State Logic
Model	THE BUS+
Category	Recording Equipment
Language	English