SOLIS BARISTA PERFETTA PLUS - CLEANING THE BREWING HEAD AND THE BREWING GROUP - PERFORMING THE CLEANING CYCLE

29
EN
● Remove the drip grid and pull the drip tray out to the front. Hand wash the
drip tray and the drip grid with mild detergent and warm water. Do not use any
aggressive cleaning agents or scouring sponges. Rinse the tray and the grid with
clear water and carefully dry both parts.
CAUTION: Drip tray and drip grid are not dishwasher safe.
● Reinsert the drip tray and place the grid back on the drip tray.
■ CLEANING THE BREWING HEAD AND THE BREWING GROUP
– PERFORMING THE CLEANING CYCLE
If the appliance emits a cleaning alarm (
button alternately flashes white and
red and the
button is lit white), you will have to clean the brewing head with the
included rubber insert (Y) and a for espresso machines suitable cleaning tablet (e.g.
URNEX Cafiza) to thoroughly remove coffee grease and other residues.
Proceed as following:
1. First empty the drip tray and place it back into the
appliance. Fill the water tank up to the Max-marking
with water. Place a container under the brewing group.
2. Now, place one of the filters for 2 cups in the porta-
filter. Place the rubber insert (Y) in the filter and put a
cleaning tablet on top. Insert the portafilter into the
brewing group.
3. Now press the Prog. button, the Prog. button and the
button flash red.
4. Now press the
button to start the automatic cleaning cycle.
5. During the automatic cleaning cycle, the
and Prog. buttons flash rapidly.
The cleaning cycle lasts less than 10 minutes, approx. 16.9 fl oz of water are led
through the brewing group. During this time the buttons cannot be operated.
6. As soon as the cleaning is finished, two signals are sounded and both coffee
buttons constantly light up white, the other buttons are not lit up.
7. Remove the portafilter from the brewing group. Rinse the portafilter, the rubber
insert, the filter and the drip tray with warm water. Re-stow the rubber insert for
the next use.