SOLIS BARISTA PERFETTA PLUS - CLEANING CYCLE HAS TO BE PERFORMED: BUTTON FLASHES WHITE; RED; DESCALING CYCLE HAS TO BE PERFORMED: BUTTON FLASHES RED; ALARM SIGNAL COFFEE DISPENSING NOT POSSIBLE: BOTH COFFEE BUTTONS FLASH TWICE AND TWO SIGNALS ARE SOUNDED

32
EN
■ CLEANING CYCLE HAS TO BE PERFORMED:
BUTTON FLASHES WHITE / RED
For the cleaning alarm, the
button
alternately flashes white and red,
the
button lights up white.
Please refer to page 29 for information on how to perform the cleaning cycle.
■ DESCALING CYCLE HAS TO BE PERFORMED:
BUTTON FLASHES RED
For the descaling alarm, the
button flashes red,
both coffee buttons light up white.
Please refer to pages 30–31 for information on how to perform the descaling cycle.
ATTENTION: It is possible that multiple alarm signals are displayed at the same time.
In such a case, each alarm should be fixed individually according to the description
in the manual, until all alarms have gone out and both coffee buttons constantly
light up white again.
■ ALARM SIGNAL
“COFFEE DISPENSING NOT POSSIBLE”:
BOTH COFFEE BUTTONS FLASH TWICE
AND TWO SIGNALS ARE SOUNDED
Possible reasons and fixes:
When water tank is empty the machine will stop to brew coffee or pouring hot water
or steaming after a few seconds.
Fill the water tank up to the Max marking and press one of the two coffee buttons.
The two coffee buttons constantly light up white if the appliance is ready for use
again.
IMPORTANT: Please always fill the tank with water after the filter has been installed
and start the settings and the rinse cycle for the new filter as described on page 17.
Coffee dispensing is not possible because the coffee is ground too finely:
The pump stops if no coffee is dispensed after 60 seconds and two signals are
sounded.
Change out the ground coffee in the filter, the coffee powder has to be less finely
ground.
x2
x2