16
6.3 SOLID Pro P(M).60 and Bifacial B.60 mounting
6.3.1 Transversal rails
• 1600 Pa wind load / 1600 Pa snow load • 1600 Pa wind load / 3600 Pa snow load
Figure 2. 6.3 SOLID Pro P(M).60 mounting with four fixing points and transversal rails.
Using four fixing points with clamps on 60 cell regular size modules allows to achieve 1600 Pa of wind
loadings and 3600 Pa of snow loads if Alumero CLICK 6.8 200 mm clamps are used. If 100 mm clamps
are used 1600 Pa of wind and snow loads can be achieved. Using four fixing points with 100 m length
clamps in portrait configuration is not recommended due to risk of panels sliding out of clamp
gaskets. It is normal that at loadings higher than 1600 Pa panels will touch the transversal rails. Please
make sure that the rail surface is smooth, because even the smallest sharp edge can cause fast
mechanical failure. If the rail surface is not smooth, sharp edges occur, it is recommended to use rail
gaskets to even the touching surface.
To Next Page
Loading...