Start-up with Loop handlebar
1. Move stop switch (1) to start position
2. Pull up fully on lever (2)
3. Push in half throttle lock (3), simultaneously
release throttle lever (2)
4. Close choke (5)
5. Push the Primer (6) several times until fuel is
visible in the bulb.
6. Hold the unit by the flange housing with the
left hand. With the right hand, slowly pull
up on the starter grip (8) until resistance is
felt, and then pull quickly and forcefully.
Repeat until the engine „pops“ or attempts
to start.
7. Immediately move choke (5) to
run position! Pull starter grip.
8. Once the engine runs, briefly apply full throttle
(2) and release to return engine RPM to idle
speed.
Start up with warm engine/start up
after brief cut-off.
Leave choke open and start engine.
If engine does not start, activate half
throttle (2). Repeat starting.
6
7
Use only the metal cutting attachments which
have been authorized by SOLO:
Grass-cutting-blade 4 teeth (69 00 706)
Grass-cutting-blade 8 teeth (69 00 693)
Maintenance: When used professionally, we
recommend the flex. shaft be removed daily
from the outer tube and lubricated with
commercially available gear grease.
1
2
3
5
6
To Next Page
Loading...
