TROUBLESHOOTING
ENGLISH 15
x Automatic lawnmower has been
carried
Place automatic lawnmower on a flat
surface and acknowledge fault.
Lift sensor
Cover has been deflected upwards
by lifting or by a foreign body.
Bumper deflected
Automatic lawnmower has
encountered an obstacle and cannot
free itself (collision close to base
No loop signal. Fault during
calibration, loop signal too weak.
x Check base station power supply
x Check loop
x Disconnect and reconnect transformer
Loop signal weak
Loop signal weak.
x Check base station power supply
x Check loop, it has possibly been buried
too deep
x Disconnect and reconnect transformer
Bad position
Automatic lawnmower is outside loop.
x Place automatic lawnmower in mowing
Automatic lawnmower has left field. Check routing of loop (curves, obstacles,
Cal: outside
Fault during calibration, automatic
lawnmower could not find loop.
x Place automatic lawnmower at right
angles to loop, automatic lawnmower
must be able to drive over loop
x Check base station power supply
x Check loop
x Disconnect and reconnect transformer
x Loop cable crossed-over
Fault during calibration, collision Remove obstacle
x Check base station for obstacles
x Check base station charging contacts
x Loop too long, too many islands
x Automatic lawnmower has got stuck
Boundary cable defective, automatic
lawnmower does not find base
Check boundary cable for interruptions, if
necessary have it tested by a SOLO
Battery exhausted. Battery service life exceeded. Have
battery renewed by a SOLO service
Charging electronics faulty. Have charging electronics renewed by a
Automatic lawnmower does not touch
charging contacts.
x Put automatic lawnmower into base
stationand check if charging contacts
make contact
x Have charging contacts checked and
renewed by a SOLO service partner
To Next Page
