Memory deletion
C
ontrols
Self-learn setting
Preparing and setting
the self-learn phase
Connecting power to the
Dexxo Pro for the first time
Un
s
crew the main cover and
remove the protective sheet.
Commissioning Instructions
F
i
t the screw-in
light bulb.
Power the unit up.
The light will flash 3
times and the LCD screen will
display S1.
230Vac
1
S1 = Up & Over or Sectional door S0 = Swing door
By default, the unit is set for Up & Over or
Sectional doors. Press the + or - buttons to
ad
just the setting for Swing doors, otherwise
continue to step 5.
2 3 4
5
Press the ‘SET’
button 3 secs.
The light will come on and
the LCD screen will display S2.
3
secs
To engage the carriage, operate the drive until the chain/belt
runner links with the carriage. Press and hold the ‘+’ button
to move in the close direction and ‘-’ in the open direction.
6 7
Once the carriage has been engaged, press the ‘OK’ button
to initiate the self-learn phase. Once the self-learn process
is completed, C1 will be displayed on the LCD screen.
Press ‘OK’ - S2 will flash and the system will cycle
t
hrough the self-learn phase
P
ress and
hold
P
ress and
hold
Programming the
remote controls
3
secs
8
Press the ‘PROG’
button 3 secs.
The light will come on and
the LCD screen will display F0.
Press the desired control button on the remote control. The
L
CD screen will display ‘--’ and the light will flash for 5
sec
onds. L
CD s
creen = C1 - The control is now recorded.
9 10
Repeat the procedure starting at step 1 to record additional
controls. The radio wall switch and digipad are recorded in
the same way. For Telis type controls, press the program
button instead of the control button.
or
Control panel overview
1 2
3
4
5
6
7
8
2
L
CD display - provides visual feedback on all
p
rogramming and operating
1
3
4
B
utton to move up through the parameter
values
B
utton to move down through the parameter
v
alues
Button use to start the self-learn phase and
t
o confirm parameter selection and value
6
B
utton use to modify a parameter value and
o
perate the rail drive during set-up
5
7
8
B
utton use to modify a parameter value and
operate the rail drive during set-up
B
utton used for various programming
f
unctions and to reset the system
Button used when programming controls and
t
o delete all controls stored in the memory
Press and hold the ‘PROG’ button. The light will come on and then begin to flash after
appr
o
x
i
mately 7 seconds (the light will flash for 5 seconds) and the LCD screen will
display ‘--’. All controls have been deleted from the memory.
7 seconds7 seconds
Press and hold the ‘SET’ button. The light will come on and
then begin to flash after approximately 7 seconds (the light
will flash for 7 seconds) and the LCD screen will display ‘--’.
The self-learn memory has been deleted.
Ob
st
acle d
et
ec
t
ion
Openi
n
g cycle
Clo
si
ng cycle
If an obstacle is detected
during the open cycle, the
door will stop
If an obstacle is detected during the
close cycle, the door will stop and
return
Commissioning procedure
Control programming
Parameter setting
To Next Page
Need help?
General
