Need help?Do you have a question about the SOMFY GDK 700 and is the answer not in the manual?
General| Speed | 140 mm/sec |
|---|---|
| Frequency | 433.42 MHz |
| Drive type | Chain drive |
| Illumination | Yes |
| Product type | Door controller |
| Certification | CE, RoHS |
| Maximum door area | 7 m² |
| Maximum weight capacity | 50 kg |
| Input frequency | 50/60 Hz |
| AC input voltage | 230 V |
| Power source type | AC |
| AC input frequency | 50 - 60 Hz |
| Operating temperature (T-T) | -20 - 60 °C |
| Country of origin | France |
| UK Trade Tariff code | 8525801990 |
| Quantity per master (outer) case | 4 pc(s) |
| Quantity per shipping (inner) case | 1 pc(s) |
Weight and Dimensions| Package depth | 165 mm |
|---|---|
| Package width | 1170 mm |
| Package height | 320 mm |
| Package weight | 13680 g |
Lists all components included in the garage door motorisation kit.
Provides essential dimensions and clearance needed for the motorisation installation.
Illustrates the typical placement of the motorisation and accessories on a garage door.
Specifies compatible garage door types, such as up-and-over and sectional doors.
Details the maximum height, width, surface area, and weight for compatible garage doors.
Lists essential tools and fasteners required for installation that are not included in the kit.
Advises on the correct types and quantities of screws for securing the unit to different surfaces.
Guides on measuring distances and preparing mounting points for the motorisation unit.
Details the process of assembling the rail, bulb, and connecting the rail to the motor head.
Explains how to fasten the unit to the lintel bracket, ceiling, and connect the link arm to the door.
Covers adjusting opening stops and checking belt tension for proper operation.
Provides instructions for connecting the motorisation unit to the mains power.
Outlines the procedure for fitting and removing the protective cover of the motor unit.
Explains how to set parameters and perform auto-programming for the motorisation.
Details how to adjust sensitivity, docking zones, and power supply type.
Describes the procedure for securing or accessing the programming settings.
Guides on how to pair remote controls with the motorisation unit.
Explains how to remove all paired remote controls from the system.
Provides instructions for resetting all programmed settings to factory defaults.
Important safety guidelines and training recommendations for end-users of the motorisation.
Explains how to operate the garage door using different types of remote controls.
Details the function and behavior of the automatic obstacle detection system.
Describes how the built-in light functions during door operation and standby.
Explains how to manually operate the door in case of power failure or malfunction.
Outlines the steps to restore normal operation after a power interruption.
Instructions for wiring and installing safety photoelectric sensors.
Guide for connecting and wiring the warning light for door movement.
Details on installing an external antenna to improve radio signal range.
Instructions for connecting a battery for operation during power outages.
Guide for installing a key-operated switch for door control.
Information on connecting a solar power supply kit for alternative energy.
Provides a comprehensive overview of how all accessories connect to the motorisation.
Recommends regular inspections to ensure the motorisation and door remain safe and functional.
Explains how to interpret indicator light codes for troubleshooting faults.
Provides contact information for seeking technical support for issues or enquiries.
Step-by-step guide on how to replace the unit's internal light bulb.
Instructions for replacing the battery in the remote control handset.
To Next Page