Need help?Do you have a question about the SOMFY Oximo RTS and is the answer not in the manual?
Wake the motor by pressing UP and DOWN buttons simultaneously until it jogs.
Check rotation direction, adjust by holding MY button if needed.
Press UP and DOWN buttons simultaneously until the motor jogs.
Press and hold the MY button until the motor jogs to confirm the limit setting.
Press PROGRAM button on transmitter until motor jogs for auto-detection.
Wake the motor by pressing UP and DOWN buttons simultaneously until it jogs.
Check rotation direction, adjust by holding MY button if needed.
Run motor to upper limit, use MY/DOWN to move down and MY to stop.
Press and hold the MY button until the motor jogs to confirm the limit setting.
Press PROGRAM button on transmitter until motor jogs for auto-detection.
Instructions for changing upper and lower motor limits after initial programming.
Wake the motor by pressing UP and DOWN buttons simultaneously until it jogs.
Check rotation direction, adjust by holding MY button if needed.
Press PROGRAM button on transmitter until motor jogs for auto-detection.
Wake the motor by pressing UP and DOWN buttons simultaneously until it jogs.
Check rotation direction, adjust by holding MY button if needed.
Run motor to lower limit, use MY/UP to move up and MY to stop.
Run motor to upper limit, use MY/DOWN to move down and MY to stop.
Press and hold the MY button until the motor jogs to confirm the limit settings.
Press PROGRAM button on transmitter until motor jogs to finalize limits.
Add or delete a remote/channel by pressing the PROGRAMMING button.
Reset motor to factory mode using a specific power cycle sequence.
To Next Page
General