What to do if my SOMFY Window Blinds motor doesn't work?
If the motor of your SOMFY Window Blinds isn't working, here are a few things you can check: * Verify the wiring of the motor. * Verify the power supply specifications. * Verify the compatibility of the control. * Verify the heat generated (wait for the cooling of the motor).
Why do my SOMFY Window Blinds stop too soon?
If your SOMFY Window Blinds are stopping too soon, consider the following checks: 1. Verify the operation of end-limits during the rotation of the motor. 2. Verify the crown is properly fitted to the tube. 3. Verify the end-limits of the motor are properly adjusted. 4. Verify that the shade is within the recommended weight limit.
Provides a description of the Sonesse® 40 motor and its applications.
Details general information and installer requirements for Somfy products.
Provides specific safety instructions and visual warnings for motor handling.
Instructions for preparing the motor, fitting crown/drive wheel, and preparing the tube.
Steps for assembling the motor into the tube and mounting the tube onto brackets.
Information on connecting the motor wires, including a table for different voltage ranges.
Procedure for initially programming an RTS transmitter to the motor.
How to verify and correct the motor's rotation direction using the RTS transmitter.
Detailed steps for setting the upper and lower travel limits for the shade.
Methods for recording the RTS transmitter after end limit setup.
Instructions on how to set and record a preferred 'MY' position.
Basic operation commands for moving the shade up, down, or to the MY position.
How to activate/deactivate the sun function and its automatic operation based on light levels.
Procedure to readjust the previously set upper and lower travel limits.
How to change or delete the saved 'MY' favorite position.
Steps to reverse the motor's rotation direction.
Steps to reverse the wheel's rotation direction.
Procedure to reset and reprogram transmitters when one is lost.
How to add or remove RTS transmitters from the motor's memory.
Procedure for adding or deleting RTS sensors.
How to perform a full reset of the motor's memory, including limits and transmitters.
Checks to perform when the motor is not functioning.
Checks to perform when the equipment stops prematurely.
Checks to perform when the equipment is making excessive noise.
Provides specifications like power supply, frequency, operating temperature, and protection rating.
Guidance on proper disposal of damaged electrical products and batteries.
To Next Page
General