Need help?Do you have a question about the SOMFY Sonesse 40 io and is the answer not in the manual?
General| Nominal Voltage | 24V DC |
|---|---|
| Control Protocol | io-homecontrol |
| Protection Class | IP44 |
| Motor Type | DC Motor |
| Radio Frequency | 868-870 MHz |
| Noise Level | 30 dB |
Provides general information and safety instructions for the drive.
Explains hazard symbols (Danger, Warning, Precaution, Attention) for safe operation.
Information required before installation and use of the drive.
Specifies the intended use of Sonesse 40 drives for interior blinds.
Steps for assembling the drive components and preparing the tube.
Details on checking tube diameter and fitting drive accessories.
Instructions for cutting, deburring, and notching the winding tube.
Guides on sliding the drive into the tube and securing the drive wheel.
Instructions for attaching the drive/tube assembly to brackets.
Electrical wiring instructions and safety precautions for the drive.
Steps to commission the drive after installation is complete.
How to pre-program the control point for the drive.
Procedure to verify and correct the motor's rotation direction.
How to set the upper and lower travel limits for the drive.
How to program a specific control point to the drive.
Steps to readjust the upper and lower end limits.
Procedure to change the motor's direction of rotation.
Advice and solutions for common installation issues.
Troubleshooting guide for common installation problems.
Instructions for replacing a lost or damaged Somfy control point.
Procedure to reset the drive to its original factory settings.
How to use the Up and Down buttons for motor control.
How to stop the motorised product using the 'my' button.
Explanation and use of the favourite position feature.
Steps to program or change the favourite position.
How to activate the programmed favourite position.
How to remove the saved favourite position.
Tips for operating the Sonesse 40 io.
Troubleshooting tips for operational issues.
Refers to another guide for adding/deleting control points and sensors.
To Next Page