SOMFY Sunea 50 CSI io - Restoring the Original Configuration; Use and Maintenance; Up and Down Buttons; Stop Function

21
EN
Images not contractually binding
Copyright © 2014-2018 Somfy Activités SA, Société Anonyme. All rights reserved.
Only switch off the power to the application to be
reset.
This reset deletes all control points, all the sensors and
all the end limit settings, and resets the motor’s favourite
position (my).
1)
Position the motorised product at the mid-height position.
2)
Cut the power supply for 2 seconds.
3)
Switch the power supply back on for 5 to 15 seconds.
4)
Cut the power supply for 2 seconds.
5)
Switch the power supply back on: the motorised product
moves for a few seconds. (If the application is at the
upper or lower end limit, it will make a brief up and down
movement).
6)
Press the PROG button on the local Somfy control point
down twice:
-
Repeat the commissioning procedure
(see Commissioning) section.
3. USE AND MAINTENANCE
This drive is maintenance-free
3.1. UP AND DOWN BUTTONS
Up or Down button causes the motorised
product to raise or lower fully.
For cassette awnings, obstacle detection is active
throughout lowering.
3.2. STOP FUNCTION
The motorised product is moving.
-
press my: the motorised product stops automatically.
3.3. FAVOURITE POSITION (my)
To use the favourite position (my):
-
press my: the motorised product starts to move,
and stops in the favourite position (my).
To modify or delete the favourite position (my), see the section entitled "Additional settings".
2 s
2 s
15 s
5 s
PROG.
1
6
5
3
2
4
OFF
OFF
ON
ON
my
1
2
3
my