Copyright © 2010 Somfy SAS. All rights reserved.
Sunilus io / Sunilus screen io
3
EN
3.3. Motor/tube assembly
Slide the motor into the roller tube. For smooth roller 1)
tubes, position the cut notch on the crown.
For safety reason, x the roller tube to the drive wheel
2)
with 4 self-tapping screws with a diameter of 5 mm or 4
steel pop rivets with a diameter of 4.8 mm located:
at least 5 mm from the far end of the drive wheel:
-
L1 - 5, and
no more than 15 mm from the far end of the drive wheel:
-
L1 - 15.
The screws or pop rivets must only be attached to the
drive wheel and not to the motor.
3.4. Fitting the tube-motor assembly
Fit the tube/motor assembly to the end bracket (C).1)
Fit the tube/motor assembly to the motor bracket (D).2)
Depending on the type of supports t the stop ring (E) 3)
[For the motors >= 85 Nm absolutely use the locking stop
ring (F)].
15 mm
5 mm
20 mm
L1
1
2
C
D
E
F
1
2
3
Always make a loop in the power supply cable to prevent
water entering the motor!
Cut the power supply off.
-
Connect the motor according to the information in the -
table below:
230 V ~ 50 Hz Motor cable
1 Brown Live (P)
2 Blue Neutral (N)
3 Yellow/Green
Earth (
)
1
2
3
1
2
3
OFF
230 V
~
50 Hz
3 x 1,5 mm
2
3 x 0,75 mm
2
4. WIRING
5065925X00_Sunilus_io.indb 3 16/02/10 11:00:38
To Next Page
Loading...
