SOMFY Sunilus io - Commissioning; Identifying Setting Steps; Pre-programming Local Control Point; Checking Motor Rotation

Copyright © 2010 Somfy SAS. All rights reserved.
Sunilus io / Sunilus screen io
4
EN
This guide describe only the comisioning using a Somfy io local control point as Situo io. For comi-
sioning using other io control point, refer to the corresponding guide.
5.1. Identifying setting steps already completed
Only one motor can be powered at a time.
Switch the power on and follow process a or b depending on
the awning reaction:
a
The awning makes a brief movement.
The end limits have been set and no Somfy io
control point has been programmed. Go to chapter
“Programming the rst Somfy io local control point”.
or
b
The awning does not move.
Press the Up or Down button and follow process c or d
depending on the awning reaction:
c
The awning still does not move
The end limits have not been set and no Somfy io
control point has been programmed.
Go to chapter “Pre-programming the Somfy io local
control point”.
or
d
The awning goes fully up or fully down
The end limits have been set and the Somfy io
control point has been programmed.
Go to chapter “ Use “.
5.2. Pre-programming the Somfy io local control point
Press the Up and Down buttons simultaneously the awning -
makes a brief movement, the Somfy io local control point
has been pre-programmed in the motor.
5.3. Checking the direction rotation of the motor
Press the Up button:1)
If the awning is raised, the direction of rotation is a)
correct: go to chapter “Setting the end limits”.
If the awning is lowered, the direction of rotation is
b)
incorrect: Press the “my” button until the awning makes a
movement, the direction of rotation has been modied.
Press the Up button to check the direction of rotation.
2)
ON
Programming the
rst Somfy io local
control point
c
or
d
Pre-programming the
Somfy io local control
point
Use
a
b
Setting the end
limits
1
2
5. COMMISSIONING
5065925X00_Sunilus_io.indb 4 16/02/10 11:00:50