Do you have a question about the SOMFY Sunis WireFree II io and is the answer not in the manual?
Power Supply | Battery |
---|---|
Communication Protocol | io-homecontrol |
Technology | Wireless |
Product type | Sensor |
Radio frequency | 868 MHz |
Communication | Radio |
Compatibility | io-homecontrol |
Range | Up to 200 meters in open space |
Details the physical components of the Sunis WireFree II io sensor, including LEDs, buttons, and battery compartment.
Instructions for programming the sensor onto a motor using a 1-way transmitter.
Steps to program the sensor on a Connexoon io device, requiring no internet connection.
Guidance on programming the sensor using the TaHoma interface.
Explains the 'Standard' mode where motors move to down end-limit when sun is detected.
Details the 'My' mode, defining specific motor positions based on sun detection.
How to switch the sensor from 'Standard' to 'My' operating mode.
How to switch the sensor from 'My' to 'Standard' operating mode.
Steps to activate the Low Power Mode for compatibility with autonomous actuators.
Steps to deactivate the Low Power Mode.
Procedure to activate the demo mode for testing sensor functionality.
Procedure to deactivate the demo mode.
How to check the current light threshold setting of the sensor.
Instructions to raise or lower the light threshold value.
List of available light threshold values (kLux) and their feedback indicators.
Guide to creating custom scenarios with specific settings and activation days.
Steps to activate the sun function using a 1-way transmitter.
Steps to deactivate the sun function using a 1-way transmitter.
Explanation of delay times for sun threshold exceedance and fall below.
Instructions for activating and deactivating the sun function via Connexoon io interface.
How to enable the sun function through the Connexoon io application.
How to disable the sun function through the Connexoon io application.
Details on light measurement intervals and order sending for 2-way systems.