– 5
Declaration of Installation
for the installation of an incomplete machine
in accordance with the Machinery Directive 2006/42/EC, Appendix II, Section 1 B
SOMMER Antriebs- und Funktechnik GmbH
Hans - Böckler - Straße 21 - 27
73230 Kirchheim unter Teck
Germany
hereby declares that the swing gate operators
STArter, STArter
+
have been developed, designed and manufactured in conformity with the
• Machinery Directive 2006/42/EC
• Construction Products Directive 89/106/EEC
• Low Voltage Directive 2006/95/EC
• Electromagnetic Compatibility Directive 2004/108/EC
• RoHS Directive 2001/65/EU
The following standards were applied:
• EN ISO 13849-1, PL "C" Cat. 2 Safety of machines - safety-related parts of controls
- Part 1: General design guidelines
• EN 60335-1/2, where applicable Safety of electrical appliances / operators for gates
• EN 61000-6-3 Electromagnetic compatibility (EMC) - interference
• EN 61000-6-2 Electromagnetic compatibility (EMC) - interference resistance
• EN 60335-2-103 Safety of electrical appliances for household and similar uses
- Part 2: Special requirements for operators for gates, doors, and windows
The following requirements of Annex 1 of the Machinery Directive 2006/42/EC are met:
1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.2.3, 1.2.4, 1.2.6, 1.3.2, 1.3.4, 1.3.7, 1.5.1, 1.5.4, 1.5.6, 1.5.14, 1.6.1, 1.6.2, 1.6.3,
1.7.1, 1.7.3, 1.7.4
The special technical documentation was prepared in accordance with Annex VII Part B and will be submitted to
regulators electronically on request.
The incomplete machine is intended for installation in a gate system only to form a complete machine as de ned by
the Machinery Directive 2006/42/EC. The gate system may only be put into operation after it has been established that
the complete system complies with the regulations of the above EC Directive.
The undersigned is responsible for compilation of the technical documents.
Kirchheim, 06-06-2015
Jochen Lude
To Next Page
Loading...
