SOMMER twist 200 E - Declaration of Installation

General Information
7
Declaration of Installation
for the installation of an incomplete machine in accordance
with the Machinery Directive 2006/42/EC, Appendix II, Section 1 B
SOMMER Antriebs- und Funktechnik GmbH
Hans-Böckler-Straße 21 - 27
73230 Kirchheim/Teck
Germany
hereby declares that the swing gate operator
twist 200 E
was designed, developed and manufactured in compliance with
• Machinery Directive 2006/42/EC
• Low Voltage Directive 2014/35/EU
• Directive on Electromagnetic Compatibility 2014/30/EU
• RoHS Directive 2011/65/EU.
The following norms were used:
• EN ISO 13849-1, PL “C” Cat. 2
Safety of machines – Safety-related parts of controls
– Part 1: General design guidelines
• EN 60335-1/2, where applicable
Safety of electrical appliances/operators for gates
• EN 61000-6-3
Electromagnetic compatibility (EMC) – interference
• EN 61000-6-2
Electromagnetic compatibility (EMC) – interference resistance
• EN 60335-2-103
General safety requirements for household and similar electrical appliances
– Part 2: Special requirements for operators for gates, doors and windows
The following requirements of Annex 1 of the Machinery Directive 2006/42/EC are met:
1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.2.3, 1.2.4, 1.2.6, 1.3.2, 1.3.4, 1.3.7, 1.5.1, 1.5.4, 1.5.6, 1.5.14, 1.6.1, 1.6.2, 1.6.3,
1.7.1, 1.7.3, 1.7.4
The special technical documentation was prepared in accordance with Annex VII Part B and will be submitted
to regulators electronically on request.
The incomplete machine is intended for installation in a gate system only to form a complete machine
as defined by the Machinery Directive 2006/42/EC. The gate system may only be put into operation after
it has been established that the complete system complies with the regulations of the above EC Directive.
The undersigned is responsible for compilation of the technical documents.
Kirchheim, 20-04-2016
i.V.
Jochen Lude
Responsible for documents