52
No Programming required. The Tuner button will turn a Zone ON if inactive, and select Tuner at the last
station selected.
Option:
This macro will have the Tuner button turn a Zone ON if inactive, select Tuner and switch to a default
favorite station.
NOTE: With this option, if the TUNER is currently selected in an ACTIVE ZONE, the station will
CHANGE to the FAVORITE when any Zone with this macro selects Tuner.
1. Select PRESS in the ACTIONS Window.
2. Left click the TUNER button in Zone 1. If the MACRO EDITOR Window opens with the DAB
Command: [THIS ZONE] SELECT SOURCE 1, proceed to STEP 3. To program: SELECT SOURCE
1 IN ZONE 1:
a) Select DAB COMMAND from the COMMAND TYPE pull down.
b) Select SOURCE from the FUNCTION pull down.
c) Select ZONE 1 from the ZONE pull down.
d) Select SOURCE 1 from the VALUE pull down.
e) DOUBLE CLICK or DRAG the DAB ICON to the MACRO LIST Window to add the step to the
macro list.
3. To select a default favorite station:
a) Select DAB COMMAND form the COMMAND TYPE pull down.
b) Select TUNER CONTROL from the FUNCTION pull down.
c) Select PRESET # from the VALUE pull down for the default favorite station.
d) DOUBLE CLICK or DRAG the DAB ICON to the MACRO LIST window to add the step to the macro
list.
e) Click OK. The Macro Editor will close and an ‘M’ will appear on the Tuner button in Zone 1 in the
Press level, to indicate that there is a macro programmed on that button, in that Zone, on that level.
NOTE: A REPEAT UNTIL BUTTON IS RELEASED Command in PRESS will defeat PRESS AND
HOLD for that button.
Press and Hold Default:
No programming required. A Press and Hold of the TUNER button will switch all Zones in PARTY MODE
to TUNER.
Option:
To scan Tuner frequencies from the Keypad using the Press and Hold function:
1. Select PRESS AND HOLD in the ACTIONS Window.
2. Left click the TUNER button in Zone 1. The MACRO EDITOR Window will open. To scan frequencies:
a) Right click the [PARTY MODE] SELECT SOURCE 1 Command. Select and left click DELETE
STEP.
b) Select DAB COMMAND from the COMMAND TYPE pull down.
c) Select TUNER CONTROL from the FUNCTION pull down.
d) Select TUNER STEP UP from the VALUE pull down.
e) DOUBLE CLICK or DRAG the DAB ICON to the MACRO LIST Window to add the step to the
macro list.
f) Click OK. The Macro Editor will close and an ‘M’ will appear on the Tuner button in Zone 1 in the
Press and Hold level, to indicate that there is a macro programmed on that button, in that zone, on
that level.
Double Press
Default:
Next Tuner Preset. No Programming required. A Double Press of the Tuner button will select the next
programmed Tuner Preset.
To Next Page
Loading...
