60
c) If the desired remote is open in Macro Editor, proceed to step ‘d’ below. If necessary, press the
SELECT NEW REMOTE Button. The SELECT REMOTE FROM LIBRARY Window will open. Scroll
through the list and select the remote for the component to be controlled. The Select Remote From
Library Window will close and the remote selected will be featured in the Macro Editor.
Manufacturers typically use the same IR codes for all of the models they produce. Try a different
remote of the same brand and component type if the specific remote for the component to be
controlled is not in the list. If a brand or component or specific command is not available, see
section: LEARNING IR CODES.
d) Scroll through the list of commands and double click Disc Skip -. The Disc Skip Rev. command will
be added to the macro list.
e) Click OK. The Macro Editor will close and an ‘M’ will appear on the STOP button in Zone 1 in the
Press level, to indicate that there is a macro programmed on that button, in that zone, on that level.
f) Repeat steps 2a-e for Disc Skip Fwd Button on the >>I button.
Double Press
None.
Panel (Numeric Buttons 1-12)
The Panel buttons are typically used to store the 12 TUNER PRESET COMMANDS in the PRESS Level.
These Presets can be selected with:
• Keypad commands
• DAB1 Front Panel button presses
• IR commands from the DAB1 Remote or other IR remote control
• RS232 commands
These buttons can also be programmed with macros for other control functions. Different commands can
be programmed in the Press, Press and Hold and Double Press levels, but the Press and Hold and
Double Press commands can only be triggered from the DAB1 Front Panel buttons.
Press
Default
To select an Internal Tuner Preset:
No programming needed. The DAB is programmed at the factory to store and select Tuner presets as
configured in TUNER SETUP.
NOTE 1: If a station frequency has not been programmed in TUNER SETUP, the DAB will not select a
preset. i.e. if preset 4 is set to 94.7 FM, the DAB will select that preset with a button press on the Front
Panel or when the DAB1 ‘sees’ the IR command for Memory Preset 4 from the DAB1 Remote. If Preset 5
has no station frequency associated, the DAB will not select that preset. For more information see: Tuner
Setup.
NOTE 2: A STATION FREQUENCY and a DAB COMMAND must be programmed in Tuner Setup and
Macro Editor respectively, to be able to select Presets.
Press and Hold
Default
No programming required. Default command is a DAB Front Panel command. A press and Hold of a
Tuner Preset button on the DAB Front Panel, will store the currently select Tuner frequency and band. A
previously stored frequency will be replaced. Changes made manually will appear in Program Manager in
Tuner Setup if a ‘Receive From Device’ is performed.
To Next Page
Loading...
