74
FCC
FCC Statement
The XP3340-A-R1 device complies with Part 15 of the
FCC rules. Operation is subject to the following two
conditions:
1 . This device may not cause harmful interference.
2 . This device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
IC Statement
The following is valid for the XP3340-A-R1 device:
1 . This Class B digital apparatus complies with
Canadian ICES-003.
2 . This device complies with RSS-310 of Industry
Canada. Operation is subject to the condition that
this device does not cause harmful interference.
To Next Page
Loading...
Need help?
Operating Environment
Display
Battery
Camera
Ports & Interfaces
Weight and Dimensions
