EasyManua.ls Logo

SONNECT Sound bullet - Declaration of Conformity

SONNECT Sound bullet
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
CE Compliance Statement
We, the manufacturer, do hereby declare that this device is
compliant with the limits of the European Council directive
on the approximation of the laws of the member states relating to
electromagnetic compatibility according to Directive 2014/30/EU and
European Low Voltage Directive 2014/35/EU.
Declaration of Conformity
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation
This equipment has been tested and found to comply with the limits
for Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.