Bluetooth pairing
Before you start, make sure your Sonos Ace is powered on and Bluetooth is enabled on the
device you want to pair your Sonos Ace with.
Note: Sonos Ace is immediately ready to pair with a Bluetooth device when unboxed and
after a factory reset.
Action Result
Press and hold the Power/Bluetooth button
(about 7 seconds) to put your headphones
into Bluetooth pairing mode.
Note: Power/Bluetooth button is located on
the left ear cup.
If you’re wearing Sonos Ace, hold the
button past the “power down” tone until you
hear the “Bluetooth pairing” tone. Any active
audio streams will stop when you enter
pairing mode.
If Sonos Ace is off your head, hold the
button until the status light slowly blinks blue.
Go to the device’s Bluetooth settings and
select your Sonos Ace from the list of found
devices.
If you’re wearing Sonos Ace,
If Sonos Ace is off your head,
You’ll hear a tone confirming that your
Sonos Ace has successfully connected
to your device.
Your device’s Bluetooth settings list will
show your headphones as “Connected.”
The status light on Sonos Ace will show
solid blue.
Your device’s Bluetooth settings list will
show your headphones as “Connected.”
To Next Page
Loading...