Sonos ZoneBridge Setup Guide
15
• Be sure that your cable/DSL modem is connected to the router’s WAN (Internet)
port.
• Temporarily remove any other components that are wired to your network.
• Connect an Ethernet cable from the computer directly to the back of the Zone-
Bridge, and then connect another Ethernet cable from the ZoneBridge directly
to one of the LAN ports on your router.
• When you make a change to your network configuration, you may need to pow-
er cycle the ZoneBridge by unplugging the power cord, and then plugging it
back in.
• If you are not using a router, visit our Web site at http://faq.sonos.com/norouter
for more information.
If you are still experiencing problems, please contact the Sonos Customer Service
Center.
Important Safety Information
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry soft cloth. Household cleaners or solvents can damage the finish on
your Sonos components.
Viper Book.book Page 15 Friday, June 29, 2007 5:01 PM
To Next Page
Loading...
