Sontex Superaqua 1 - Radio Setting; Device Display Loop

12 Instruction for use | Superaqua 1
6.5 Radio setting
If other transmission times and/or a different radio telegram are required, these can be
congured using an NFC read/write head or a NFC compatible smartphone and the Software
Superprog, see chapter "Radio settings conguration" . The water meter can also be pro-
grammed with other radio settings ex works on customer request.
6.6 Device display loop
Display Display time Example
10 s
Consumption 36.214 m
3
Current ow rate 15 l/h
3 s optional
Set day value 175 m
3
Check number c85
Set day 01.01
Min. 1 s
(can be exten-
ded)
Firmware Version
1 s minimum Segment test all OFF
1 s minimum Segment test all ON
Depending on the delivered device conguration, the display runs through different contents.
Here is a typical example with the display of the set day value. The display of the "set day
value" can optionally be switched off using the Software Superprog as well as the display of
the "current ow rate".