Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections 35
Screws removed from the
camcorder
CAC-12
Microphone
holder
M4 × 6 screws
Microphone adaptor
Using an Optional Microphone
To use a long microphone such as the optional ECM-
670/672, remove the supplied microphone holder, and
fit an optional CAC-12 Microphone Holder to the
camcorder, then mount the microphone in this holder.
Removing the supplied microphone
holder
Remove the two microphone holder retaining screws
(M4 × 6) from the viewfinder, remove the microphone
holder, then replace the screws in their original
positions.
Fitting the optional CAC-12 Microphone
Holder
Remove the two retaining screws (M3 × 8) for the
optional microphone holder, then use these screws to
attach the CAC-12 Microphone Holder.
Fitting an optional microphone
Use the following procedure to attach an optional
ECM-670 Microphone.
1 Loosen the screw of the CAC-
12 Microphone Holder, then
open the holder and replace the
microphone adaptor with the
one supplied with the ECM-
670 Microphone.
(Continued)
To Next Page
Loading...
