84
2 Hold down [/1, and enter the
manufacturer’s code for your AV
amplifier (receiver) using the number
buttons (see “Code numbers of
controllable AV amplifiers (receiver)”
below).
3 Release [/1.
The VOL +/– buttons control the AV
amplifier’s volume.
◆ If you want to control the TV volume
Slide the TV/DISC EXPLORER/DVD
switch to TV.
Code numbers of controllable AV
amplifiers (receivers)
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your AV amplifier
(receiver).
* If you cannot control the volume of your Sony AV
amplifier (receiver) with the remote, try entering
the code number 91, and change the command
mode of your amplifier (receiver) to
“COMMAND MODE [AV1]” (not all amplifiers
have this option).
Refer to the instructions supplied with your
amplifier (receiver) to change the command
mode.
z Hint
If you want to control the TV’s volume even when
the TV/DISC EXPLORER/DVD switch is set to
DVD, repeat steps 1 and 2 and enter the code
number 90 (default).
Manufacturer Code number
Sony* 80, 88, 89, 91
Denon 84, 85, 86
Kenwood 92, 93
Onkyo 81, 82, 83
Pioneer 99
Sansui 87
Technics 97, 98
Yamaha 94, 95, 96
To Next Page
Loading...
