CDX-757MX
16
3-3. GEAR (LOMINI)/(LOAD 1) ASSY
3-4. OPERATION CHECK
1
Confirm that the slider moves in the direction of arrow
C
to move down
the chuck plate if the gear (LOAD 1) is rotated in the direction of arrow
A
or the chuck plate moves up and the slider moves in the direction of
arrow
D
if the gear is rotated in the direction of arrow
B
.
gear (LOAD 2)
gear (LOMINI)
marking
Fig. A
chuck plate
2
Attach the gear (LOMINI) at the position
shown in Fig. A.
shaft (rotary prevention C)
1
Move the lever (LOCK 3A)
fully in the direction of arrow
B
to move the chuck plate up.
B
4
stop ring 1.5 (E type)
3
Attach the gear (LOAD 1) assy
with its facing inside.
slit
chuck plate
slider
gear (LOAD 1) assy
A
B
C
D
To Next Page
