Sony 7700 - Page 4

Sony 7700 (Y2K) 17/03/00
Page 4 of 8
Multimod User Instructions
Your DVD player is originally hard-coded for a specific geographical region. This
means that it normally allows playback of software that is matched to your region
only. There are some solutions that patch the player to "region 0", i.e. “region free” to
allow playback of other region specific software - we do not recommend this as many
new titles can detect this and refuse to play.
With our DVD MultiMod you have user selectable region code. You will be able to
select and switch between the region codes on your player. You can choose between
the region 1 to 6. You can switch between any of these modes easily. When a disc
asks the player for the region the player will report the region code you entered, thus
allowing you to play all the latest movies. Just pick the correct region code for the disc
and your disc will play right away.
In order to play DVDs from other regions on your DVD player, the player has to be set
to the correct region.
On your model:
Region selection is auto + manual.
You may leave the player in auto selection mode or select manual region selection.
The available commands are listed in the table below.
Region Keys on Remote to
press
Player’s Default Region #
Region 1 (USA/Canada)
Region 2 (Europe/Japan)
Region 3 (Hongkong)
Region 4 (Austrailia)
Region 5 (Taiwan)
Region 6 (China, Russia)
Automatic Region Selection #
Manual Region selection
Vcr mode on (macrovision off) #
Vcr mode off (macrovision on)
User Prohibitions disable #
User Prohibitions on
Sync on Green
Sync on Video #
IRE 7.5
IRE 0.0
IRE Default #
RGB
YUV
RGB / YUV Default #
0 Enter
1 Enter
2 Enter
3 Enter
4 Enter
5 Enter
6 Enter
0 Angle Change
0 Audio Change
1 Angle Change
1 Audio Change
2 Angle Change
2 Audio Change
3 Audio Change
3 Angle Change
4 Audio Change
4 Angle Change
4 Subtitle Change
5 Audio Change
5 Angle Change
5 Subtitle Change
# Defaults after installation and power cycling.