36
wireless LAN router closer to each
other.
, Devices that use a 2.4 GHz frequency
band, such as a microwave, Bluetooth,
or digital cordless device, may
interrupt the communication. Move
the player away from such devices, or
turn off such devices.
The desired wireless router is not
shown in the wireless network list.
, Press RETURN to return to the
previous screen, and try [Wireless
Setup(built-in)] again. If the desired
wireless router is still not detected,
select [Manual registration].
The message [A new software version
is available. Please go to the "Setup"
section of the menu and select
"Network update" to perform the
update.] appears on the screen when
turning the player on.
, See “Network Update” (page 27) to
update the player to a newer software
version.
The [Control for HDMI] function does
not work (BRAVIA Sync).
, Check that your TV is connected via
the HDMI OUT 1 jack. If your TV is
connected via the HDMI OUT 2 jack,
BRAVIA Sync is disabled.
, Check that [Control for HDMI] is set
to [On] (page 31).
, If you change the HDMI connection,
turn the player off and on again.
, If power failure occurs, set [Control
for HDMI] to [Off], then set [Control
for HDMI] to [On] (page 31).
, Check the following and refer to the
instruction manual supplied with the
component.
– the connected component is
compatible with the [Control for
HDMI] function.
– the connected component’s setting
for the [Control for HDMI] function
is correct.
, When you connect the player to a TV
through an AV amplifier (receiver),
– if the AV amplifier (receiver) is not
compatible with the [Control for
HDMI] function, you may be unable
to control the TV from the player.
– if you change the HDMI
connection, disconnect and
reconnect the mains lead, or a power
failure occurs, try the following:
1Switch the input selector of the
AV amplifier (receiver) so that the
picture from the player appears on
the TV screen.
2Set [Control for
HDMI] to [Off], then set [Control
for HDMI] to [On] (page 31). Refer
to the instruction manual supplied
with the AV amplifier (receiver).
The System Power-Off function does
not work (BRAVIA Sync).
, Check that [Control for HDMI] and
[HDMI:Linked to TV-off] are set to
[On] (page 31).
Playback does not start from the
beginning of content.
, Press OPTIONS, and select [Play from
start].
“Control for HDMI” (BRAVIA
Sync)
Others
To Next Page
Loading...
