Selects
the
audio
signals
output
when
playing
Dolby
Digital
discs.
This
setting
affects
the
output
from the
DIGIT
AL
OUT
(COAXIAL/OPTICAL)
jack.
Downmix
Converts to output Linear
PCM
PCM signals. Select this
when connecting an audio
device without a built-in
Dolby Digital decoder.
Dolby Digital
Select this when connecting
an audio device with a built-
in Dolby Digital decoder.
Selects
the
audio
signals
output
when
playing
DTS
discs.
This
setting
affects the
output
from
the
DIGITAL
OUT
(COAXIAL/
OPTICAL)
jack.
Downmix
Converts to output Linear
PCM
PCM
signals. Select this
when connecting to an audio
device without a built-in
DTS decoder.
DTS
Select this when connecting
--
to an audio device with a
built-in DTS decoder.
Selects
the
maximum
sampling
frequency
for
the
PCM
signals
output
from
the
DIGITAL
OUT
(OPTICAL/COAXIAL)
jack.
48kHz/16bit
Outputs audio signals
of
96 kHz sampling as 48 kHz/
16 bit.
96kHz/24bit
Outputs audio signals
of
96
kHz sampling as 96 kHz/
24 bit. However, the signals
will be output as 48 kHz/
16 bit
if
the source
is
copy-
protected.
"
If
you select "96kHz/24bit" when
an
AV amplifier
(receiver) that does not support 96 kHz
is
connected,
no
sound or a loud sound may result.
Selects
the
dynamic
range
(compression
level
of
the
sound)
setting
when
playing
a
BD
or
DVD
that
conforms
to
"Audio
DRe."
Auto Performs playback at the
--
dynamic range specified by
the disc (BD-ROM only).
Other discs are played back
at the "Standard" level.
Standard
Performs playback at a
compression level between
"TV
Mode" and "Wide
Range."
TV
Mode
Sounds are compressed
heavily. Low sounds are
easier to hear.
Wide
Range
No compression works. A
more dynamic sound is
produced.
"
• "Audio DRC"
is
effective only
when
playing
Dolby Digital, Dolby Digital Plus, and Dolby
TrueHD audio signals.
• When "Dolby Digital"
is
set to "Dolby Digital"
in
the "Audio Settings" setup (page 47), "Audio
DRC" has
no
effect
on
the audio output from the
DIGITAL OUT (OPTICAL/COAXIAL) jack
(except when "BD Audio Setting"
is
set
to
"Mix"
when playing a BD).
Sets the
downmix
method
of
multi-channel
to
two-channel
sound.
Dolby
Outputs the Dolby Surround
Surround
(Pro Logic) signals in 2
channels. Select this when
connecting an audio device
that supports Dolby
Surround (Pro Logic).
Normal
Outputs audio signals
without Dolby Surround
(Pro Logic) effect. Select
this when connecting an
audio device that does not
support Dolby Surround
(Pro Logic).
"
"Downmix"
has
no
effect
on
the bitstream audio
output from
the
DIGITAL OUT (OPTICAL/
COAXIAL)/HDMI OUT jack.
•
47
To Next Page
